Baer Energie- & Messtechnik GmbH
Home Information Products News Software Contact Sitemap
    

Analogue Modem UniMod 01/I

UniMod 01/I  



Brief description
 

The universal analogue (PTT: Post, Telegraph and Telephone Administration) modem UniMod 01/I is supposed for remote inquiry of measurement data of any kind, especially however for telecounting applications.
For the UniMod 01/I communication modules produced by internationally renowned companies are used. These companies update their software packages regularly and add or change features. The software releases are continuously checked by the development department, but no responsibility for this software releases can be take over except of warranty granted by the module producer.
The modem has a built-in, low-loss switched power supply, which enables it to operate on a wide-range AC or DC supply voltage.
The modem can be programmed with the Hayes AT command set.

Housing outline drawing

Please note: Product available in limited quantities.




Interfaces
 

The interface for connecting the target device can be specified by plugging the appropriate interface module. The following module types are available now:

  • CS (20 mA current loop) interface module, active (supplies current) or passive
  • RS232 interface module (uses signals RxD, TxD, CTS, RTS, GND)
  • RS485 interface module
  • M-Bus interface module, active (can supply 10 devices max.) or passive


Technical Data
 
Housing: Wall-mounted housing
Degree of protection: IP52 (IEC)
Abmessungen: W = 105 mm,
H = 179 mm,
D = 72 mm
Protection class: 1
Supply voltage: AC: 80V~ bis 270V~
DC: 60V= bis 375V=
Power consumption:

About 4 VA
(depends upon supply voltage, kind of interface module and operating status of transmission unit)

Interfaces: Plug-in modules; available are:

- RS232 (supports signals RxD, TxD, RTS, CTS, GND, DTR, DCD/DSR)
- CS (20 mA current loop) active or passive
- RS485
- M-Bus active (can supply 10 devices max.) or passive
Display: LED’s for signals: operation, Rst, Hook, TxD, RxD and DCD.
Transmission rate remote modem to UniMod: 300 – 14400 bit/sec (V.21 / V.22 / V.22bis / V.32 / V.32bis / V.34),
tone or pulse dialling
Transmission rate UniMod to connected device: 300 to 19200 Baud, automatic baud rate detection
Transmission mode: 7E1, 8N1, 8E1, ...
Data compression: V.42bis / MNP5
Error correction: V.42 / MNP4
Password: Possible
Remote access: Possible
Data Transmit Control: Possible
Reset circuit: optional: every 3, 6, 12 or 24 hours
License: EU-License CETECOM CE0682, reg. no. D800739K
Extent of delivery: - UniMod 01/I including interface module as ordered
- Standard cable TAE (length of cable about 3m)
- Operation manual
Accessories: - Adapter for parametering (#9177)
- Additional interface modules
- Parameterization software UniModSet / MetcomTSet
Download as PDF File: UniMod 01/I Flyer (Filesize 251K)
UniMod 01/I Operation Manual (Filesize 908K)

to SURVEY of Modems      Top of Page
 



UniMod 01/I housing outline drawing
 
Housing outline drawing 1
 
Housing outline drawing 2
 
Housing outline drawing 3
 


to SURVEY of Modems
 


Relays
Modems
UniMod
  LTE
  GSM-4
  ETHERNET
   01/I
  UniModSet
  Antennas
Data
Logger
Software
M-Bus/RS485
Special
Product
Family
Modules
Service
 

Top of Page

 Home    |    Information    |    Products    |    News    |    Service    |    Contact us    |    Sitemap

Copyright © Baer Energie- & Messtechnik GmbH

Last Update 28.03.2019 at 14:53:17.